Idées d’organisation de garage

Idées d’organisation de garage

Idées d’organisation de garage

A good thing about the wood pallet is that, it is easy to do and fits for many hammering needs in a home or shop. Because of its simplicity in nature, one can easily make it a hobby. When you make a wooden template, you need a number of tools that make your work easier. In order to successfully complete the template project, training tools are important; You need separation tools, skew, thickness and coarse crusher.

When making a hammer, you will need a length tree of about 6 "length of 3 1/4" square for the hammock head, and another piece with a length of 12 "and width of 1 1/4" square of the handle. The next step you need to do now is to mark the middle of both ends of these pieces of wood to find the center. This is easily done by measuring the corner corners, where the lines are crossed. Mount the large square on the wooden spindle with the help of the located centers to align the piece.

Rotate the Mallet Head by hand, this is supposed to test the blanks stability and alignment on the wooden spindle before turning on the turning and start turning the pendant. When the wood is rounded and balanced, you can increase its speed gradually, higher speed will result in a smother cut. Calibration ensures that the wood has an even diameter along the length of the piece. Use the shear tool to locate both ends of the grille head, you should leave a short tendon and then remove with a saw

You can now make some decorative patterns near both ends of the fabric, and then release the plot from the wooden cord. Use a saw to cut off the remaining tendons. Now you just need to drill a hole in the middle of the head where the handle is mounted. To do this we can get a drill press to drill the hole for the handle. Make a jig to keep your head on your head to keep your head stable, usually a large "V" notch in another piece of wood will suffice to hold the round head. Drill a vertical hole for the handle in the middle, both at the end to the end and from side to side.

The next step is to make the bucket handle. Mount the small square in the wooden spindle, the procedure is the same as for the template head. Use the coarse bolt, around the blades and shape the handle to your personal design. Check that the handle diameter meets your requirements; fits your hand. Create a short cut to match the diameter of the hole you drilled in the hanging head. The tendon should have a small taper, from smaller than the drilled hole to larger than the drilled hole, which will ensure a tight fit. Remove the tendons again with a saw.

Both Mallet Head and Handle have been sanded and the tendons removed, you can paste the two pieces together. After the glue is dry, apply a layer of oil to maintain the hanger. Mineral oil, linseed oil, heavy oil, or whatever you ever want, I like to remove form lacquer as it tends to be smooth and makes a good grip difficult.